Compatibility: Only for operation on 24 Volts vehicle electrical systems! Technical data: UP 10DSP – 24V Edition Output power RMS – @ 4 Ohms Channels A – H: 8 x 65 Watts – @ 2 Ohms – – @ 1 Ohm – – bridged @ 4 Ohms – – bridged @ 2 Ohms – – Subwoofer output @ 4 Ohms Channels I – J: 2 x 90 Watts – Subwoofer output @ 2 Ohms Channels I – J: 2 x 160 Watts Amplifier technology Class GD Inputs 8 x Highlevel speaker input 1 x Optical SPDIF (12 – 96 kHz) 1 x Remote In Input sensitivity Channels A – F: 4 – 16 Volts Channels G – H: 4 – 16 or 8 – 32 Volts Input impedance RCA / Cinch – Input impedance highlevel 9 – 33 Ohms with ADEP.3 Outputs 10 x Speaker output 1 x RCA / Cinch 1 x Remote Out Output voltage RCA / Cinch 3 Volts Frequency response 10 Hz – 22, 000 Hz DSP resolution 64 Bit DSP power 295 MHz (1.2 billion MAC operations/second) Sampling rate 48 kHz DSP type Audio signal processor Signal converters A/D: BurrBrown D/A: BurrBrown Signal-to-noise ratio digital input 105 dB (A-weighted) Signal-to-noise ratio analog input 103 dB (A-weighted) Distortion (THD) 0.03 % Damping factor 100 Operating voltage 18 – 36 Volts (max. 5 sec. down to 12 Volts) Power rating DC 24 V ⎓ 32 A max. Idle current 210 mA Max. remote output current 500 mA Operating temperature range -40° C to +70° C Fuse 2 x 25 A LP-Mini-fuse (APS) Additional features Class GD technology with dynamically controlled power supply, 32 Bit CoProcessor, ADEP.3 circuit, Start-Stop capability, Smart Control Port, USB, MEC slot, Auto Remote switch, galvanically isolated Line Out Dimensions (H x W x D) 46 x 145 x 163 mm / 1.81 x 5.71 x 6.42" Scope of delivery: 1 x MATCH UPGRADE amplifier UP 10DSP – 24V Edition 2 x Connection cable 1 x Mounting plates & material 1 x USB cable 1 x Instruction manual